9.6W / m 24V LED strip 5m, CRI> 80 120led / m IP20

(1 customer review)
A +

Absolutely brilliant value for money LED strip with dense LED 120 m / m, CRI> 80 and about ~ 1000 lm / m. The IP20 LED strip is 8mm wide and 5m long, with 12cm soldered connecting wires at each end of the strip. The color of the light is very warm white 2700K, warm white 3000K, neutral white 4000K and cold white 6000K. There is 3M tape on the bottom of the LED strip to attach the strip to its base. Great for a wide range of lighting purposes in dry interiors, including the kitchen. Also available IP65 version with NANO coating for bathrooms and outdoor areas!

Poista

Kuvaus

Affordable LED strip with dense LED 120led / m and good light output ~ 1000lm / m

The LED strip can be installed very close to the ceiling or wall surface or the diffuser, and the light emitted by the individual LEDs of the light strip is no longer detectable, but the light is even and pleasant. Can be cut every 6 LEDs or 5cm.
  • The product is tested in approved laboratories

  • We recommend additional cooling for the LED strip, e.g. With LED profile.

    This tape is 8mm wide, which means it can fit in all our profiles. Our most affordable surface-mounted profile is 14.4mmx7mm DIRECT12, which works well for basic lighting. If you do not want to see the LED points, select MINI10 profile with dimensions of 12x12mm. The profiles corresponding to flush-mounted ones are the most preferred basic profile DIRECT UPPO12 and a pointless result is obtained MINI-UPPO10 profile. From corner models PT45 profile there will also be a perfectly flat and neat finish with this LED strip.
  • The high quality of the light meets the EU requirements for indoor lighting

  • You also need a 24V constant voltage source. If you use the whole 5 meter LED strip then 5 x 9.6W = 48W, ie we recommend this 75W 24V constant voltage source! If you are installing 2 strips, ie a total of 10m, there is a suitable transformer for example 120W 24V constant voltage source. These transformers also work if you want to dim the tape with wireless dimmers like this affordable SMART LED dimming set. This tape also looks great looking like a standard wall controller in our RF WiFi series wireless rotary roller controller and RF WiFi 12-24V receiver, which allows the wireless controller to control the LED strip.
  • If you want to dim the tape with traditional wall dimmers, such as a transistor or TRIAC dimmers, choose a TRIAC dimmable transformer, for example a full 5m coil 75W 24V TRIAC transformer.
  • 3-year manufacturer's warranty (Average service life 36000 h)

Model DJ120-24V
Operating voltage 24VDC
Power W / m 9.6W
Light output, 2700K ~ 900lm
Light output, 3000K ~ 960lm
Light output, 4000K ~ 1040lm
Light output, 6000K ~ 1000lm
Efficiency 105-114 lm / W
Opening angle 120º
Led  2835
LED / m 120
CRI > 80
Reel length 5m
Dimensions (mm) 5000x8x1.5

Declarations of Conformity: CE & RoHS

Käyttölämpötila -20º - +45º

The product is manufactured using LEDs that have been tested to the 6000h requirement according to LM-80.

Additional information

Weight 0.1 kg
Dimensions 25 × 25 × 3 cm
Light color

2700K, 3000K, 4000K, 6000K

IP class

IP20

Voltage

24V

Power W / m

9,6

Number of LEDs LED / m

120led / m

1 review for 9,6W/m 24V LED-nauha 5m, CRI>80 120led/m IP20

  1. Jukka K. (verified owner) -

    Good basic tape and affordable.

Add a review

You may also like…

  • Rated 0 out of 5
    DIRECT12 LED profile 2m
    9,9012,90
      Poista

      DIRECT12 LED profile 2m

      Edullinen ja monikäyttöinen! Pinta-asennettava 14,4mm x 6,6mm alumiinilista max. 12mm leveälle LED-nauhalle, loistava LED-profiili esimerkiksi keittiön välitilaan kolmessa värissä.

      Available as accessories end pieces and sliding cover or J diffuser as well as a clickable cover C diffuser, shades of opal and bright. Mounting clips model S adjustable and S conical hole fit this profile. If you connect the two profiles to each other for a longer whole, you can fasten them tightly using the fastening clip at the joint and also install the diffuser seam in a different place than the profile seam. This locks the profiles comfortably straight into line.

      Tuotetunnus: 1322
      Avainsanat tuotteelle , 1322
      9,9012,90

      DIRECT12 LED profile 2m

      9,9012,90

      Edullinen ja monikäyttöinen! Pinta-asennettava 14,4mm x 6,6mm alumiinilista max. 12mm leveälle LED-nauhalle, loistava LED-profiili esimerkiksi keittiön välitilaan kolmessa värissä.

      Available as accessories end pieces and sliding cover or J diffuser as well as a clickable cover C diffuser, shades of opal and bright. Mounting clips model S adjustable and S conical hole fit this profile. If you connect the two profiles to each other for a longer whole, you can fasten them tightly using the fastening clip at the joint and also install the diffuser seam in a different place than the profile seam. This locks the profiles comfortably straight into line.

      Poista
    • Rated 0 out of 5
      75W 24V LED transformer HELVAR, constant voltage
      50,00

      Saatavilla heti 4 kpl

      Saatavilla heti 4 kpl

      75W 24V LED transformer HELVAR, constant voltage

      24V, 75W powerful HELVAR IP20 LED constant voltage source with 85% efficiency. Surge protection, overheating protection and short circuit protection.

      50,00

      Saatavilla heti 4 kpl

      75W 24V LED transformer HELVAR, constant voltage

      50,00

      Saatavilla heti 4 kpl

      24V, 75W powerful HELVAR IP20 LED constant voltage source with 85% efficiency. Surge protection, overheating protection and short circuit protection.

      Saatavilla heti 4 kpl

    • Rated 0 out of 5
      PT45 LED corner profile with cover, end pieces and mounting clips, length 2m
      19,90

      Saatavilla heti 2 kpl

      Saatavilla heti 2 kpl

      PT45 LED corner profile with cover, end pieces and mounting clips, length 2m

      Anodized corner-mounted LED corner profile in anodised aluminum with opal, slightly curved, cover, end pieces (2pcs) and mounting clips (4pcs included in the package). The dimensions of the profile are 16 x 16mm and the profile is designed for max.10mm LED strips. Sold as a ready-made set, ie the corner profile includes an opal-colored cover, end pieces and 4 mounting clips for mounting.

      19,90

      Saatavilla heti 2 kpl

      PT45 LED corner profile with cover, end pieces and mounting clips, length 2m

      19,90

      Saatavilla heti 2 kpl

      Anodized corner-mounted LED corner profile in anodised aluminum with opal, slightly curved, cover, end pieces (2pcs) and mounting clips (4pcs included in the package). The dimensions of the profile are 16 x 16mm and the profile is designed for max.10mm LED strips. Sold as a ready-made set, ie the corner profile includes an opal-colored cover, end pieces and 4 mounting clips for mounting.

      Saatavilla heti 2 kpl

    • Rated 0 out of 5
      Wall control / dimmer 1-channel. + monochrome LED strip receiver 12-24V - EASY RF
      18,9034,90
        Poista

        Wall control / dimmer 1-channel. + monochrome LED strip receiver 12-24V - EASY RF

        An affordable and practical surface-mounted LED wall controller and receiver for controlling monochrome LED strips. Easy to install, just connect the receiver between the 12V or 24V LED strip and the transformer and install the batteries in the controller and connect the devices. Works wirelessly and dims without blinking and good dimming all the way to the end.

        Tuotetunnus: 19259
        Tag: 19259
        18,9034,90

        Wall control / dimmer 1-channel. + monochrome LED strip receiver 12-24V - EASY RF

        18,9034,90

        An affordable and practical surface-mounted LED wall controller and receiver for controlling monochrome LED strips. Easy to install, just connect the receiver between the 12V or 24V LED strip and the transformer and install the batteries in the controller and connect the devices. Works wirelessly and dims without blinking and good dimming all the way to the end.

        Poista