Diffusers

The diffuser is LED profile cover, that breaks the light opening of the light, further expanding it. Diffusers differ in light permeation and technical properties. Profile model Depending on, you can choose a transparent, dim or more covering and light -softening opal (milk) cover.

For luminous power to weaker <6W strips The profile can light transparentof/frostedn cover to make the light output better through the lid. Note, however, that the LED points are visible. In addition to the tone of the lid, it is affected by how close cover is LEDtape. For example, a 12mm high mini10 profile is already enough with a 120LED/m opal cover for scoring. In low profiles such as surface10 or Begton12, scores appear unless there are use dotless COB LED strip, for the profile is only about 6mm. Worktops, kitchen intermediate space etc. where the light is in front of the eyes, we recommend the opal (milk) cover. Milk glass diffuser spread the light of the LEDs evenly and LED-The light points are not visible and the light is soft. Also, with the opal cover, the LED points do not dazzle. The product page of each diffusor shows aluminum profiles to which that cover Fits.

The covers also differ from the installation method.

To slide in cover There is a simple plastic ribbon with 3 different transparency. cover Install by pushing it in and pulling along the groove in the profile. The lids to slide are a model: A, B, E, G, H, J. Printable cover Press directly from the profile inside the profile. End pieces do not need to be installed but cover Can be pressed in place. Pressing covers are designed: C, D, F, I, C9, C10, C3, C2 and C1