RGBW LED strips

---

RGBW The ribbons are 12mm wide and dimmable and cut off, depending on the strip, every 5-10cm to a suitable size. If you want to illuminate the corner of the corner, or two adjacent walls, it would be easiest to feed the ribbons from the corner in two directions, you can connect the cables of both strips to the same receiver. You can also cut off in the corner strip and solder it to a short 5. OS flat cable At the corner and solder the flat cable to the next ribbon. Also strip-Sholmo quick connectors can be found RGBWfor the ribbons, but accurate the dimensions in order to the connectors fit inside the profile you choose. RGBW The ribbons are almost unlimited, for example Smart LED 2.4g with a series of light controllers or Zigbee with light controllers (can also be connected to the Philips Hue system). If you want dotless light, we recommend LEDto -profile Square or Line20 our profiles. You need RGBW LED-In addition to the ribbon, the profile to which RGBW You install the tape to provide a neat installation, 24v LED-In transformer (eg 5M for installation 19.2W/m 24v RGBW tape 120W 24V power supply, because 5m x 19.2W/m = 96W and the transformer should be a little bigger than this.) In addition, you need a light controller, for example we recommend receiver and to that controller eg wall control or remote control. These light control products are 2.4g of our series And very easy to use and directly combined with voice control, such as Amazon Alexa or Google Assistant.