15W/m 12V RGB COB LED strip IP20

dotless 12V COB RGB LED strip 15W/m 12V 5m coil, with 5 years warranty, particularly suitable for use at trade fairs, restaurants, in cars, etc. IP20, for indoor use. RGB-strip for restaurants, event lighting, home ambient lighting, etc. RGB LED strip in one chip, 720 LEDs per metre. Both ends pre-soldered with approx. 30cm wires! See product brochure here.

RGB COB LED strip - 15W/m 12V RGB-light ribbon with colours

LED-Red, blue, green LED, which can be mixed in millions of different colours.

RGB LED-The ribbon is controlled by a variety of light control products. The easiest solution is Our RF WiFi series RGB compatible receiver combined with for example a remote control, with pre-set programmes for colour changing shades, a tilt wheel for adjusting the light tone and dimming. In addition RGB LED-strips can be controlled by, for example. DMX decoders.

In addition, our new Smart LED 2.4G is the affordable receiver and remote control and wall controller RGB adjustment.

For example, if you are using the whole 5m tape for one object, the transformer can be used for example. 75W 12V constant voltage transformer. Because even if the ribbon has a total of 14W x 5m = 72W, not all the LEDs on the ribbon will light up at the same time. RGBW LED-So a slightly smaller strip is fine. power supply than is usually recommended, i.e. +20-30% higher than the power requirement.

• Luminous flux red 620-630nm: 144lm/m
• Luminous flux green 520-530nm: 303lm/m
• Luminous flux blue 450-460: 48lm/m

Applications RGB LED-tape

• Trade fairs
• Restaurants
• Shopping centres
• Homes
• Indirect mood lighting, etc.

RGB LED-tape specifications

• Flexible drying space RGB LED strip i.e. multi-coloured LED strip
• Protection class: IP20
• Voltage: 12V DC DC, 12V DC DC voltage, so use standard 12V power supplies
• Full reel length: 5 meters
• Power: 15W/metre
• Width: 10 mm
• Height: 2.2 mm
• Shade: RGB Multicolour ribbon
• LED Type: COB RGB
• 720 led/m
• LED opening angle: 120°
• Dimmable and RGB controllable

RGB-Other information on the tape

• Operating environment: -25°...60°C
• strip can be cut at intervals of approximately 2.5 cm
• On the back of the tape, 3M double-sided tape that sticks to almost anything
• Flexible, but not lateral
  

RGB light control:

• Light control requires RGB-A controller, such as the RF WiFi series receiver and controller.

• RGB-controls, see here

• Colour options RGB in the driver information. The main colours are red, green, blue and white, with the possibility of mixing these with a wide range of colours. There is a very wide range of programmes. From calmer to faster. Brightness and speed can be adjusted.

• max. 5m traction LED-tape, but if necessary RGB with an amplifier the length of the installations can be increased without limit or if e.g. 7m RGB-tape is powered from both ends, in which case power supply is in the middle with wires to each end.